DigiDesign MachineControl Spezifikationen PDF herunterladen (Seite 38)

MachineControl Guide34

Arming Tracks Remotely for

Layback

To arm tracks remotely for layback, you need to

first configure Track Arming for your machine.

To configure Track Arming:

1 Make sure your machine is properly con-

nected and configured to slave to Pro Tools.

2 Open the Track Arming window.

3 Select a Record Protocol (Auto Edit or Punch

In/Out).

4 Select a Record mode (Insert or Assemble).

To perform a layback:

1 In Pro Tools, select the audio to lay back, or

place the playback cursor at a start point.

2 In the Remote Track Arming window, arm the

appropriate tracks on the machine.

3 Select Transport = Machine in the Pro Tools

Transport window.

4 Make sure the Pro Tools Transport is online.

5 Click Record in the Transport window to arm

recording.

6 Click Play in the Transport window.

Your machine will cue to the selection start mi-

nus all relevant pre-roll, then begin to play back.

Pro Tools will then sync to the deck, and the tar-

get deck will record as determined by your set-

tings for Record Protocol and Record mode. If

you did not create an on-screen selection, deck

recording will continue until you manually stop

playback.

Once the Track Arming options are config-

ured, you can change the Track Arming

window to “small view” and still see the

track arm buttons.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Keine Kommentare

DigiDesign MachineControl Spezifikationen Seite 38