DigiDesign Control 24 Spezifikationen PDF herunterladen (Seite 134)

Control|24 Guide124

To conﬁgure Automation Write On Stop modes to

remain enabled after an automation pass:

■ While holding CTL/CLUTCH and

OPT(ALT)/ALL, press the START, END, or ALL

switch in the WRITE AUTOMATION TO section.

The switch lights to indicate that Write on Stop

will remain enabled.

Automating Plug-Ins

Control|24 supports Pro Tools features for the

writing of dynamic automation of plug-ins.

To record dynamic automation of a plug-in:

1 Use the AUTOMATION ENABLE switches to

make sure that Plug-In Automation is globally

record-enabled.

2 Choose an automation mode for the channel

you wish to automate by doing one of the fol-

lowing:

• Pressing the channel’s AUTO switch to step

through automation modes.

– or –

• Pressing the channel’s AUTO switch, while

pressing a master AUTOMATION MODE

switch.

3 Display the plug-in’s parameters by pressing

the channel’s INSERT, EQ, or DYN switch, fol-

lowed by INSERTS/PARAM, to place Control|24

into Parameters mode. In this mode, the encod-

ers can be used to enter and record parameter

automation data.

4 Press PLAY. Automation recording begins, and

adjustments to the encoder knobs will be re-

corded as automation data.

5 Rotate the channel encoder to write automa-

tion moves. Following all Pro Tools settings for

touch time-out and thinning, automation will

be recorded to the plug-in automation playlist.

6 You can punch-out of automation recording

at any time by pressing the appropriate AUTO-

MATION ENABLE switch.

Arming and Disarming Plug-In

Parameter Automation

In plug-ins, parameters must be individually en-

abled for automation recording by selecting

each from within the Plug-In Automation win-

dow.

Control|24 provides direct and immediate ac-

cess to plug-in automation enabling in the AU-

TOMATION section.

To enable automation for any parameter:

1 Select the desired plug-in to make it the con-

troller focus.

2 Press the AUTO/SELECT switch.

3 Press the encoder switches below the parame-

ter names in the scribble strips that you want to

automate. The encoder switch LEDs will light,

and “AUTO” followed by “ON” will ﬂash brieﬂy

in place of the parameter name in the scribble

strips.

4 Begin automation recording and adjust pa-

rameters as needed.

If you want to add additional automation

moves or augment your previous pass, fol-

low the previous procedure but select Auto

Touch or Auto Latch modes. These enable

you to add new automation only when you

actually move an encoder knob.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 158 159

Kommentare zu diesen Handbüchern

Keine Kommentare