DigiDesign Control 24 Spezifikationen PDF herunterladen (Seite 85)

Chapter 10: Navigation and Editing 75

Scrub with Trim

Control|24 supports Trim/Scrub mode, which

lets you scrub to locate an edit point, then trim

to that point in one operation.

To use Trim/Scrub:

1 Identify and navigate to a region or selection

you want to Trim/Scrub.

2 Press and hold either the SCRUB or SHUTTLE

switch for at least one second (wait for the TRIM

switch to ﬂash) to enable Trim/Scrub mode.

– or –

To focus the Trim/Scrub at the end of a selection

or selected region, hold Alt (Windows) or Op-

tion (Mac) while enabling Trim/Scrub mode.

3 Move the Scrub/Shuttle wheel as needed to

scrub or shuttle.

4 To trim to the current scrub/shuttle location,

press TRIM, SCRUB, or SHUTTLE. To cancel

without trimming, press STOP, PLAY, or ES-

CAPE.

If no region is selected when Trim/Scrub mode is

enabled, scrub begins from the edit cursor loca-

tion and will trim to the right. Holding the Alt

(Windows) or Option (Mac) key reverses the

Trim tool and will trim to the left.

As with normal Scrub, hold Alt (Windows) or

Option (Mac) to scrub from selection or region

end.

Using Shuttle Mode

To use Shuttle mode:

1 Press the SHUTTLE switch while Pro Tools is

not playing or recording.

2 Rotate the shuttle wheel clockwise to shuttle

audio forward, or counter-clockwise to shuttle

backward. The REW and FWD switch LEDs will

light (just like the on-screen Transport buttons

in Pro Tools). The shuttle start position will be

the location of the Edit cursor for a current

waveform selection, or the location of the Play-

back cursor location if there is no current selec-

tion.

Using the Numeric Keypad for Shuttle “lock”

Mode

While in Shuttle mode, you can use the numeric

keypad to control shuttle speed (with “0” being

off, +9 being the fastest forward shuttle and –9

being the fastest reverse shuttle speed). The +/–

keys are used to control shuttle lock direction of

play.

There are two ways to exit Shuttle mode:

■ Press the SHUTTLE switch or any of the Trans-

port switches.

– or –

■ Press the spacebar on the computer keyboard,

while pressing ESC/CANCEL on Control|24, or

pressing (CTL)+“.” (period).

About Scrub/Shuttle “Lock Out” Behavior

When Scrub or Shuttle is engaged, most other

controls are “locked out.” Only the following

Control|24 or Pro Tools controls will be avail-

able for use:

◆ Scrub/Shuttle wheel and switches

◆ Any TRANSPORT switch (disengages

Scrub/Shuttle and reverts Control|24 to normal

transport modes)

◆ Modiﬁer switches

◆ Channel faders

◆ MUTE and SOLO switches

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 158 159

Kommentare zu diesen Handbüchern

Keine Kommentare